Авторизация
Логин:
Пароль:
Регистрация
Забыли свой пароль?
Подписка на новости
Новое в блогах
В блоге пока нет сообщений

 

Nissan Cima 2001

Поиск  Пользователи  Правила 
Закрыть
Логин:
Пароль:
Забыли свой пароль?
Регистрация
Войти
 

Страницы: 1
RSS
Nissan Cima 2001, Прописать кнопки
 
Здравствуйте. Кто-нибудь знает, как привязать кнопки ключа к авто (ключик треугольником с тремя кнопками)  Перебрал все известные процедуры - безуспешно ((. Двери закрыл, ключ вставил-вытащил 6 раз, авто пропиликало, замки открылись, а дальше ничего не происходит.. ^help_me^
Изменено: Igrik - 08.04.2015 22:26:05
 
попробуйте так

Program OEM teardrop keys as follows:1.Ins ert working metal key in Ign and turn on.2. Go into Nissan then Euro then Primera, ins ert pin code. (2000-2002 uses fixed 5523 2003-2004 uses Random BCM Supercodes Pin)(Regular cable, black dongle on Pro)3. Remove metal key from Ign and place each teardrop key to be programmed in to Ign without turning on. theft light blinks 5 times for each key. (Max 4 keys??)4. Start car with 1st key used to close out programming.5. Program RKE buttons on board same as other Nissan remotes.*Used remotes are re-usable, as sub can use an NI02 chip * If using an NI02 blank the rubber head would need to be shaved down to fit in to Ign.
 
Тагир, спасибо, но не то. Авто у меня заводится. Нужна процедура ручной привязки кнопок (лок, анлок) именно на эту модель.
 
M45 & Q45 models equipped with this style Remote.
Remote Program Procedure:
(No tester needed)
The Remote buttons must be programmed before the transponder chip in the
Remote can be programmed.
→ Sit in car and close & lock all the doors.
→ Use the mechanical metal key to ins ert & remove in to the igniton lock cyl
-
inder very fast 6 times within 10 seconds.
→ Note: Make sure each time you remove the key all the way.
→ The emergency warning lights should blink twice.
→ Insert the mechanical metal key and turn to the “ACC” position.
→ Press any button on the Remote and the emergency warning lights should
blink twice. If only programming one remote, open the drivers door to close
the cycle. Double check Remote functions.
→ If programming more than one Remote, use the drivers door electric lock
buttons to Unlock the door and then to Lock it again. Press any button on
the Remote and the emergency warning lights should blink twice.
→ You can program up to 4 Remotes this way. Openning the drivers door
will close the cycle
Страницы: 1
Читают тему (гостей: 1)